Rockwell Automation 1769-L3xx CompactLogix System Quick Start - Manual (Page 141)

Publication IASIMP-QS001C-EN-P - October 2009 141
Add Distributed I/O Modules to the Project Chapter 11
Test the Distributed I/O Light
EtherNet/IP, ControlNet, and DeviceNet
1. Move the keyswitch on your controller to RUN.
2. Select the PB and press Ctrl+T.
This toggles the state from 0 to 1 (off to on).
3. Verify that the light on both the local and distributed digital
output modules turn on.
4. Press Ctrl+T to toggle the state back to 0 (off).
5. Select Go Offline.
Off
On
ControlNet
Shown