Configure the devicenet network, Before you begin, What you need – Rockwell Automation 1769-L3xx CompactLogix System Quick Start User Manual
Page 91: Chapter 9, Configure the devicenet, Network, Before you begin what you need
91
Publication IASIMP-QS001C-EN-P - October 2009
91
Chapter
9
Configure the DeviceNet Network
In this chapter, you configure the DeviceNet node address for the 1769-SDN module. You
also create the RSNetWorx for DeviceNet file that stores network configuration.
Before You Begin
•
Prepare the computer, see
.
•
Install all hardware, see Chapters
•
Connect the 1769-SDN module, the 1734-ADN adapter and the PowerFlex drives to a
DeviceNet network.
This example uses KwikLink right-angle male cables with sealed micro connectors
connected to flat cable with terminator/resistors on each end.
•
Verify that power is applied to all devices.
What You Need
•
Power supply and tap for the DeviceNet network.
This example uses the 1606-XLDNET8 and a KwikLink power tap module.
•
RSNetWorx for DeviceNet software.