Brocade Communications Systems RFS6000 - Manual (Page 369)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 367
53-1001931-01
Crypto IPSec config commands
9
show
Crypto IPSec config commands
Use this command to view current system information running on the controller
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
NOTE
The following commands display only for the Mobility RFS6000 Controller and the Mobility RFS4000
Controller:
- power
The following commands display only for the Mobility RFS7000 Controller and the Mobility RFS4000
Controller:
- port-channel
- static-channel-group
Syntax
show <paramater>
Parameters
Example
RFController(config-crypto-ipsec)#show ?
aclstats Show ACL Statistics information
alarm-log Display all alarms currently in the system
autoinstall autoinstall configuration
banner Display Message of the Day Login banner
boot Display boot configuration.
clock Display system clock
commands Show command lists
crypto encryption module
debugging Debugging information outputs
dhcp DHCP Server Configuration
environment show environmental information
file Display filesystem information
firewall Wireless firewall
ftp Display FTP Server configuration
history Display the session command history
interfaces Interface status
ip Internet Protocol (IP)
ldap LDAP server
licenses Show any installed licenses
logging Show logging configuration and buffer
mac Internet Protocol (IP)
mac-address-table Display MAC address table
mac-name Displays the configured MAC names
management Display L3 Managment Interface name
mobility Display Mobility parameters
? Displays all the parameters for which information can be viewed
using the show command