Brocade Communications Systems RFS6000 - Manual (Page 697)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 695
53-1001931-01
Wireless configuration commands
20
•
server [primary|secondary] [<IP> {acct-port <port>}|
radius-key [0 <key>|2 <key>|<key>]] – Sets the primary or
secondary RADIUS server for the selected WLAN.
•
primary – Sets primary RADIUS server information
•
secondary – Sets secondary RADIUS server information.
•
<IP> – Sets the IP address of the RADIUS server.
•
acct-port <port> – Sets the optional radius server
accounting port. Default is 1813.
•
radius-key [0 <key>|2 <key>|<key>] – Sets the
radius-key for the RADIUS server.
•
0 <key> – The key is sent unencrypted.
•
2 <key> – The key is sent encrypted with the
password-encryption secret.
•
<key> – The shared key.
•
timeout <1-300> retransmit <1-100> – Sets the time
the controller waits for a response from the RADIUS
server before retrying. This is a global setting for both
the primary and secondary servers.
•
retransmit <1-100> – Number of retries before the
wireless controller will give up and disassociate
wireless client
•
<1-100> – Retry count
•
reauth <30-65535> – Enable periodic reauthentication of all
associated wireless-clients.
•
<30-65535> – The reauthentication interval in
seconds.
secure-beacon Does not include the SSID of this WLAN in beacon frames
set-vlan-user-limit
[<1-4094>|<vlan-list>]
<0-8192> Sets user limits on VLANs for this WLAN
•
[<1-4094>|VLAN] – VLAN range list. It can be either a single
index, a list (1,3,7) or a range (3-7) of indices
•
[<0-8192>] – Sets the VLAN index. The limit is
<0-8192>
smart-scan-channels
[<channel-list>|
add <channel-list>|
remove <channel-list>] Specifies a list of channels to brocade clients to perform a
smart-scan. The following are the options set:
•
<channel-list> – A comma separated list of channels to scan.
Can also contain a single channel number.
•
add <channel-list> – Adds the specified channel(s) to the
smart-scan list.
•
remove <channel-list> – Removes the specified channel(s)
from the smart-scan list.
ssid <ssid> Enter the SSID of this WLAN. <ssid> can be up to 32 characters.
storm-control
[bcast|mcast|ucast]
rate-limit <rate> Enables packet dropping in case of flooding attack.
•
bcast – broadcast packets
•
mcast – multicast packets
•
ucast – unicast packets
•
rate-limit <rate>– Enables rate limiting if the rate exceeds
the value set by <rate> (1-1000000 packets/second).
syslog accounting server
<IP> {port <1-65535>} Syslog Accounting
•
accounting – Modifies accounting parameters
•
server <IP> – Modifies the Syslog accounting server IP
Address.
•
port <1-65535> – Optional. Defines the Syslog server port.
The default port number is 514 .