Brocade Communications Systems RFS6000 - Manual (Page 623)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 621
53-1001931-01
Wireless configuration commands
20
Parameters
For all the above parameters, the following optional values are set:
Example
RFController(config-wireless)#debug cc ?
access-point access-point logs
all all modules
alt address lookup logs
access-point Sets the parameters for the access-point logs
all Sets the parameters for all the modules
alt Sets the parameters for the address lookup logs
ap-containment Sets the parameters for the ap-containment logs
ap-detect Sets the parameters for the Rogue AP detection logs
capwap Sets the parameters for the CAPWAP logs
cluster Sets the parameters for the cluster related logs
config Sets the parameters for the configuration change logs
dot11 Sets the parameters for the datapath logs
eap Sets the parameters for the 802.11x eap logs
ids Sets the parameters for the intrusion detection logs
kerberos Sets the parameters for the kerberos logs
l3-mob Sets the parameters for the Layer-3 mobility logs
loc-ap Sets the parameters for the AP locationing logs
loc-client Sets the parameters for the Client locationing logs
media Sets the parameters for the encapsulation media logs
wireless-client Sets the parameters for the wireless-client logs
radio Sets the parameters for the radio logs
radius Sets the parameters for the radius client logs
self-heal Sets the parameters for the self healing logs
smart Sets the parameters for the smart-rf logs
snmp Sets the parameters for the snmp logs
system Sets the parameters for the system call logs
wips Sets the parameters for the WIPS sensor logs
wisp Sets the parameters for the WISP logs
wlan Sets the parameters for the WLan logs
debug all the messages are logged
err only error and higher severity messages are logged
info only information and higher severity messages are logged
warn only warning and higher severity messages are logged