Brocade Communications Systems RFS6000 - Manual (Page 718)

716 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
RTLS config commands
21
reference-tag
RTLS config commands
Configures fixed RFID tag as reference tag and sets its coordinates within a specified location
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
reference-tag rfid <tag-id> coordinates x <0-65535> y
<0-65535> {[z<0-65535>]}{orientation [0|90|180|270]}
{range <1-50>}
Parameters
Usage Guidelines
Use
[no] reference-tag rfid <tag-id> (coordinates x <0-65535> y <0-65535>)
(orientation (0|90|180|270)) range <1-150>]
to rollback the reference-tag configuration.
Example
RFController(config-rtls)#reference-tag rfid Brocade coordinates x
600 y 600 orientation 180 range 40
RFController(config-rtls)#
rfid <tag-id> coordinates x
<0-65535> y <0-65535> {[z
<0-65535>]} {orientation
[0|90|180|270]} {range
<1-50>} Configures rfid tag as a reference tag
•
coordinates – Configures tag location
•
x <0-65535> – Configure X coordinate
•
y <0-65535> – Configure Y coordinate
•
z<0-65535> – Configure Y coordinate
•
orientation – Configures reference tag orientation
(angles in degrees)
•
0 – Increments only X
•
90 – Decrements only X
•
180 – Decrements only Y
•
270 – Increments only Y
•
range <1-50> – Configures tag read range in feet.