Brocade Communications Systems RFS6000 - Manual (Page 595)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 593
53-1001931-01
Wireless configuration commands
20
Parameters
Usage Guidelines
Use
{no} aap auto-upgrade enable
to disable the auto-upgrade facility on the controller
Example
RFController(config-wireless)#aap config-apply mesh-delay 300
RFController(config-wireless)#
RFController(config-wireless)#aap fwupdate mode test
aap fwupdate mode test
RFController(config-wireless)#
RFController(config-wireless)#aap fwupdate stagger-count 1
RFController(config-wireless)#
aap-version [br7131]
<version-number> Enables version number
•
br7131
•
<version-number> – Configures minimum ap version
required for adoption. A firm version string in the format
X.X.X.X-XXXR
auto-upgrade enable Enables automatic firmware upgrade of Adaptive AP on the
controller
config-apply
[def-delay|mesh-delay]
<30-10000> Applies AAP configuration settings
•
def-delay – Sets the default time to delay before applying
AAP configuration
•
<30 -10000> – Set the delay time (in seconds)
•
mesh-delay – Defines the interval to delay before applying
AAP configuration to Mesh APs
•
<3--10000> – Set the delay time
(in seconds)
fwupdate
[<1-256>|
<LISt>
|ip-address|location|mode
password|stagger-count|
unadopted|username] Manually upgrades the specified Advanced AP. The options are:
•
<1-256> – Updates the AAP based on its index number
•
<LIST> – Updates the AAP based on its MAC Address.
An AAP can be updated based on either a single MAC
address or a list of MAC addresses or a range of MAC
addresses. Use the show wireless ap command to view
the AP index
•
ip-address – Sets the remote SFTP server IP address .
•
location – Specifies the path name of the firmware image in
the remote SFTP server
•
mode – Firmware upgrade mode ftp/sftp. Default is ftp.
•
password – SFTP server password
•
stagger-count <1-10> – Configure simultaneous upgrade
count
•
<1-10> – Number of simultaneous upgrades to
perform.
•
unadopted – Updates the unadopted AAPs
•
username – Username to login to the SFTP server.