Brocade Communications Systems RFS6000 - Manual (Page 601)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 599
53-1001931-01
Wireless configuration commands
20
Parameters
<1-256>
[ABG
Scan|adoption-policy|aap-a
dmin-passwd||aap-log-stora
ge|aap-syslog-srvr|country-c
ode|leds|location|
name|secure-code|
secure-mode-stagging
|aap-ipfilter-list |
aap-lan1-ipf-rules|aap-lan1-t
runking] Sets a single AP index. Use the show wireless ap command to
view the AP’s index value.
•
ABG Scan enable – Configures the ABG scan mode on the AP
•
enable – Allows detector radio to perform ABG scan
•
adoption-policy [allow|deny]– Specifies adoption policy
•
allow – Allow adoption
•
deny – Deny adoption
•
aap-log-storage (enable) – Configure storage of AAP log
messages file
•
enable – Enables storage
•
aap-syslog-srvr (enable) (level <0-7> <ipaddr> )– Configures
aap syslog output.
•
enable – Enables syslogging
•
level <0-7> – Specify syslog level
•
ipaddr – Specify server IP address
•
country-code <country-code> – Defines the country of
operation for the ap. Regulatory configurations such as
channels will be configured automatically.
•
leds (enable) – Configures ap LEDs
•
enable – Enables LEDs
•
location <location> – Defines the location description of the
AP
•
<location> – A string of upto 40 charactersname <name> –
Sets the name of this AP
•
<name> – A string of upto 40 characters
•
secure-mode [enable|secret] – WISPe secure mode.
Configures a shared secret to a set of APs (specified by LIST).
The AP's MAC, shared secret will be saved in the running
configuration file. If this command is not executed for an AP,
default pre-shared secret will be assigned.
•
enable – Configure secure-mode to a set of APs
(specified by LIST). The AP's MAC and mode will be
saved in the running configuration.
If secure-mode is enabled, the WISP-e for this AP is
secured
•
secret [0 <secret>|2 <secret>|<secret>] – Secret is a
string of up to 64 characters
•
0 – Password is specified UNENCRYPTED
•
2 – Password is specified encrypted with
password-encryption secret
•
<secret> – If the secret <secret> is not specified then
default secret will be used
•
secure-mode-staging enable – WISPe secure mode staging
•
enable – Configure secure-mode staging to a set of APs
(specified by LIST). The AP's MAC, and staging mode will
be saved in the running configuration.
In this mode, controller will send configured shared
secret in the clear in the Join response to the AP.
•
Use the {no} secure-mode-staging enable
command to negate.
•
aap-admin-passwd – Configure aap admin password
•
aap-ipfilter-list – Configures aap IP filter listaap-lan1-ipf-rules
– Configures aap Lan 1 IP filter rules.