Tweco 400 Ultra-Cut(March 2013) - Manual (Page 49)

Manual No. 0-5163 3-23 INSTALLATION
ULTRA-CUT 400
Locate the Cooler so that there is adequate ventilation in front of and behind the unit and do not place or stack
anything on top of the unit.
2’ (0.6 m)
2’ (0.6 m)
3”
76 mm
3”
76 mm
Art # A-09623
NOTE
Ensure the four coolant lines described below are connected and leak free before connecting power to J71.
Match the colors of the hoses to the front panel label. Supply lines are green and return lines are red. Facing the
unit as shown below, the left connections go to the UltraCut power supply, the right connections go to the RAS1000
arc starter.
CAUTION
Do NOT cross the coolant lines as this will not provide cooling for the XT-300 plasma torch as designed and void
the warranty.