Ultra-cut 400 – Tweco 400 Ultra-Cut(March 2013) User Manual
Page 54
INSTALLATION
3-28
Manual No. 0-5163
ULTRA-CUT 400
5. Connect Control cable from the Power Supply to J56 on the front of the DMC-3000 as shown below. The
Fiber Optic cable will be covered a little later.
Art # A-09142
6. Install WMS Water Softener Kit in the line that feeds the inlet side of the DMC-3000. Mount the softener and
bracket on the power supply where the provided 2’ hose can reach to the DMC-3000. Mounting in another
location is possible with a customer provided hose. Below is typical customer added hose and installation.
Art # A-09655
7. Make sure that the hose going to the DMC-3000 is connected to the port on the WMS Water Softener marked
“OUT” and the incoming water supply connected to the port marked “IN”. Do not mount over any elec-
tronics or outlets in case of leaks during operation or spills when changing the element at a later date.