Figure 3-7. removing and installing a memory riser, Installing a memory riser, Installing a memory – Dell PowerEdge R910 User Manual
Page 101
Advertising
Installing System Components
101
Figure 3-7. Removing and Installing a Memory Riser
Installing a Memory Riser
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 89.
3 If applicable, remove the memory-riser blank. See "Removing a Memory-
CAUTION:
Before installing the memory riser, you must ensure that the memory
module socket ejectors are in the locked position.
1
handle 2
memory
riser
3
release button
4
card guide
5
memory-riser connector
1
3
2
4
5
book.book Page 101 Tuesday, December 4, 2012 3:11 PM
Advertising