Dell PowerEdge R910 - Manual (Page 59)

About Your System 59
The memory
configuration is
not optimal. The
recommended
memory
configuration
is: <message>
Invalid memory
configuration. The system
will run but with reduced
functionality.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 92. If the problem
persists, see
"Troubleshooting System
Memory" on page 181.
Write fault
Write fault on
selected drive.
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard-
drive subsystem.
Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected. See
"Troubleshooting a USB
Device" on page 174,
"Troubleshooting an Internal
USB Key" on page 183, and
"Troubleshooting a Hard
Drive" on page 186.
Warning: QPI
links operating
in Slow Speed
Mode.
The processor has bent pins.
The processor is not properly
seated on the processor
socket.
Verify that there are no bent
pins on the processor. If the
processor has bent pins, see
"Getting Help" on page 203.
Reseat the processors. See
"Removing a Processor" on
page 147 and "Installing a
Processor" on page 151.
If the problem persists, see
"Getting Help" on page 203.
Warning: QPI link
between <Agent X>
Port <Y> and
<Agent X1> <Port
Y1> failed.
Warning: QPI link
between <Agent X>
Port <Y> and
<Agent X1> <Port
Y1> degraded to
half-width.
NOTE: For the full name of an abbreviation or acronym used in this table, see the
Glossary at dell.com/support/manuals.
Message Causes Corrective Actions
book.book Page 59 Tuesday, December 4, 2012 3:11 PM