Dell PowerEdge R910 - Manual (Page 88)

88 Installing System Components
System Identification Panel
Removing the System Identification Panel
1 If applicable, remove the front bezel. See "Removing the Front Bezel" on
page 87.
2 Pull the system identification panel out of its slot in the chassis, until it is
in the lock position. See Figure 3-3. The system identification panel is
located above the hard drive slot 8.
3 To release the left portion of the system identification panel, pull the panel
to the right until it disengages from the slot in the chassis.
4 To release the right portion of the system identification panel, pull the
panel to the left until it disengages from the slot in the chassis.
Figure 3-3. Removing and Installing the System Identification Panel
1 system identification panel
1
book.book Page 88 Tuesday, December 4, 2012 3:11 PM