Dell PowerEdge R910 - Manual (Page 133)

Installing System Components 133
I/O Card
Removing the I/O Card
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 If applicable, disconnect the external cables connected to the I/O card.
3 Open the system. See "Opening the System" on page 89.
4 Grasp the card by its edges and lift the card to remove it from the I/O card
connector. See Figure 3-1 for the location of the I/O card in the system.
5 If applicable, remove the internal dual SD module. See "Removing the
Internal Dual SD Module" on page 138.
6 If applicable, remove the iDRAC6 enterprise card. See "Removing an
iDRAC6 Enterprise Card" on page 137.
book.book Page 133 Tuesday, December 4, 2012 3:11 PM