Installing a power supply – Dell PowerEdge R910 User Manual
Page 155
Installing System Components
155
Figure 3-31. Removing and Installing a Power Supply
Installing a Power Supply
1 Verify that power supplies are the same type and have the same maximum
output power.
NOTE:
The maximum output power (shown in watts) is listed on the power
supply label.
2 If applicable, remove the power supply blank. See "Removing the Power
3 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-31.
NOTE:
If you unlatched the cable management arm in step of the previous
procedure, relatch it. For information about the cable management arm, see
the system’s rack documentation.
4 Connect the power cable to the power supply and plug the cable into a
power outlet.
1
power supply
2
locking tab
3
cable retention bracket
1
2
3
book.book Page 155 Tuesday, December 4, 2012 3:11 PM