Dell PowerEdge R910 - Manual (Page 150)

150 Installing System Components
CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
13 Carefully lift the processor out of the socket and leave the release lever up
so that the socket is ready for the new processor.
After removing the processor, place it in an antistatic container for reuse,
return, or temporary storage. Do not touch the bottom of the processor.
Touch only the side edges of the processor.
Figure 3-29. Removing and Installing a Processor
1
2
3
4 5
6
book.book Page 150 Tuesday, December 4, 2012 3:11 PM