Dell PowerEdge R910 - Manual (Page 137)

Installing System Components 137
Removing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 If applicable, disconnect the Ethernet cable from the iDRAC6 Enterprise
Card connector on the system back panel. See Figure 1-3.
3 Open the system. See "Opening the System" on page 89.
4 Remove the I/O card. See "Removing the I/O Card" on page 133.
5 If applicable, remove the VFlash media card from the iDRAC6 Enterprise
Card. See "Removing a VFlash Media Card" on page 138.
6 Pull back slightly on the two tabs at the front edge of the card and gently
lift the front edge of the card off of the retention standoffs.
As the card releases from the standoffs, the connector under the card
disengages from the system board connector.
7 Install the plastic filler plug over the port on the I/O card.
8 Install the I/O card. See "Installing the I/O Card" on page 134.
9 Close the system. See "Closing the System" on page 90.
10 Reconnect the system and peripherals to their power sources, and turn
them on.
book.book Page 137 Tuesday, December 4, 2012 3:11 PM