Dell PowerEdge R910 - Manual (Page 48)

48 About Your System
Memory Riser <x>
disabled - No
Memory detected.
The memory modules are not
properly seated.
The memory module
connector may be exposed to
dust.
Unsupported memory
module.
Replace or reseat the
memory module(s). See
"Removing Memory
Modules" on page 105 and
"Installing Memory Modules"
on page 102.
Verify that the memory
modules are identical and
not in a locked step pair.
Memory Riser <x>
disabled -
Invalid DIMM.
Unsupported memory
modules in the first locked
step pair.
See "General Memory
Module Installation
Guidelines" on page 92.
Replace the memory
modules. See "Removing
Memory Modules" on
page 105 and "Installing
Memory Modules" on
page 102.
Memory Riser <x>
disabled - No
DIMM detected.
An empty memory riser is
installed.
Install memory modules in
the riser. See "General
Memory Module Installation
Guidelines" on page 92.
DIMM
unsupported:
Memory Riser <x>
DIMM<y>
Memory Riser<x>
Lockstep pair
DIMM <y & z>
disabled
Please replace
the DIMM or
remove the
lockstep pair
Unsupported memory
modules on slots 3 to 8.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 92.
Message Causes Corrective Actions
book.book Page 48 Tuesday, December 4, 2012 3:11 PM