Removing lcd status messages, Table 1-1. lcd status messages – Dell PowerEdge R910 User Manual
Page 24
24
About Your System
Removing LCD Status Messages
For faults associated with sensors, such as temperature, voltage, fans, and so
on, the LCD message is automatically removed when that sensor returns to a
normal state. For other faults, you must take action to remove the message
from the display:
• Clear the SEL — You can perform this task remotely, but you will lose the
event history for the system.
• Power cycle — Turn off the system and disconnect it from the electrical
outlet; wait approximately 10 seconds, reconnect the power cable, and
restart the system.
NOTE:
The following LCD status messages are displayed in the simple format. See
"Setup Menu" on page 16 to select the format in which the messages are displayed.
Table 1-1. LCD Status Messages
Code
Text
Causes
Corrective Actions
E1000
Failsafe
voltage
error.
Contact
support.
Check the SEL for critical
failure events.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
E1114
Ambient Temp
exceeds
allowed
range.
Ambient temperature has
reached a point outside of
the allowed range.
E1116
Memory
disabled,
temp above
range. Power
cycle AC.
Memory has exceeded
allowable temperature and
has been disabled to prevent
damage to the components.
Remove AC power to the
system for 10 seconds and
restart the system.
See "Troubleshooting
the problem persists, see
book.book Page 24 Tuesday, December 4, 2012 3:11 PM