Figure 3-23. removing and installing the i/o card, Installing the i/o card – Dell PowerEdge R910 User Manual
Page 134
Advertising
134
Installing System Components
Figure 3-23. Removing and Installing the I/O Card
Installing the I/O Card
1 If applicable install the iDRAC6 Enterprise card. See "Installing an
iDRAC6 Enterprise Card" on page 135.
2 If applicable, install the internal dual SD module. See "Installing the
Internal Dual SD Module" on page 140.
3 Holding the card by its edges, position the card so that the card-edge
connector aligns with the I/O card connector.
4 Insert the card-edge connector firmly into the I/O card connector until the
card is fully seated.
1
I/O card
2
I/O card connector
1
2
book.book Page 134 Tuesday, December 4, 2012 3:11 PM
Advertising