Dell PowerEdge R910 - Manual (Page 139)

Installing System Components 139
5 Disconnect the SD module cable.
6 Pull back slightly on the tabs at the edge of the card and gently lift the
edge of the card off of the retention standoffs.
7 Install the I/O card. See "Installing the I/O Card" on page 134.
8 Close the system. See "Closing the System" on page 90.
9 Reconnect the system and peripherals to their power sources, and turn
them on.
Figure 3-25. Removing and Installing the Internal Dual SD Module
1 retention standoff posts (3) 2 retention standoff tabs (3)
3 SD module cable 4 dual SD module
2
1
3
4
book.book Page 139 Tuesday, December 4, 2012 3:11 PM