Dell PowerEdge R910 - Manual (Page 47)

About Your System 47
Memory Riser <x>
disabled - SMI
channel training
failure.
The memory riser connector
is not properly seated.
The memory riser connector
or the processor socket may
be exposed to dust.
The processor has bent pins.
Reseat the memory riser(s).
See "Removing a Memory
Riser" on page 100 and
"Installing a Memory Riser"
on page 101.
Ensure that the memory riser
connectors and processor
sockets are clean.
Verify that there are no bent
pins on the processor. If the
processor has bent pins, see
"Getting Help" on page 203.
Memory Riser <x>
disabled - Memory
Buffer
communication
error.
Memory Riser <x>
disabled -
MemBIST error.
The memory modules are not
properly seated.
The memory module
connector may be exposed to
dust.
Unsupported memory
module.
Replace or reseat the
memory module(s). See
"Removing Memory
Modules" on page 105 and
"Installing Memory Modules"
on page 102.
Ensure that the memory
module connectors are clean
and supported memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 92.
Memory Riser <x>
disabled -
MemBIST timeout.
Memory Riser <x>
disabled - Rank
not found.
Memory riser <x>
disabled - DIMM
communication
error
Memory Riser <x>
disabled - DDR
training failure
Memory Riser <x>
disabled - Simple
memory test
failure.
Message Causes Corrective Actions
book.book Page 47 Tuesday, December 4, 2012 3:11 PM