I english, Trouble check – Sony DCR-TRV7 User Manual

Page 95

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

I

English

Trouble check

If you run into-.inv problem iisinj; the

Should the difficulty persist, disconne
.tuthorized Sony serv ice facility.

camcorder, use the following table to troubleshoot the problem,

ct the power source and contact your Sony dealer or local

Camcorder

Power

Symptom

Cause and/or corrective actions

rhe power is not on.

The battery pack is not installed.

Install the battery pack. (p. 7)

The battery is dead.

Use a charged battery pack. (p. 7)

The AC power adaptor is not connected to a wall outlet.

Connect the AC power adaptor to a wall outlet, (p. 27)

rhe power goes oft.

While being operated in CAMERA mode, the camcorder has

been in Standby mode for more than 5 nrinutes.

Set the POWER switch to OFF, then to CAMERA, (p. 13)

The battery is dead.

Use a charged battery pack. (p. 7)

rhe battery pack is quickly discharged.

The ambient temperature is too low. {p. 83)

The battery pack has not been charged fully.

Charge the battery pack again, (p. 7)

The battery pack is completely dead, and cannot be recharged.

■>

Use another battery pack. (p. 27)

Operation

Symptom

Cause and/or corrective actions

START/STOP does not operate.

The tape is stuck to the drum.

■>

Eject the tape. (p. 11)

The tape has run out.

^

Rewind the tape or use a new one. {p. 23)

The POWER switch is set to VTR.

^

Set it to CAMERA, (p. 12)

The tab on the cassette is out (red).

■>

Use a new tape or slide the tab. (p. 11)

rhe cassette cannot be removed from

he holder.

The battery is dead.

Use a charged battery pack or the AC power adaptor,
(p.

7

,

27

)

B

and

^

indicators flash and no function • Moisture condensation has occurred.

except for cassette ejection works. Remove the cassette and leave the camcorder for at least 1

hour. (p. 89)

'CLOCK SET" appears when the
.amcorder is turned on.

Reset the date and time. (p. 81)

rhe End Search function does not
iCtivate. , .

The cassette was ejected after you recorded on it.

The End Search function will not activate until you make a
new recording after reinserting the cassette.

The tape without cassette mempry ejected after recording.

>

a

Continued to the next page

95

Advertising