Sony DCR-TRV7 - Manual (Page 96)

Trouble check
Operation
Symptom Cause and/or corrective actions
Tlio tape does not n^o\’e when a tape
transport button is pressed. •
•
The POWRR switch is set to CAMERA or OFF.
-> St't it to VTR. (p. 23)
The tape has run out.
Rewind the tape or use a new one. (p. 23)
No sound or only a low sound is heard
when playing back a tape. •
•
The volume is turned to the minimum.
•> Open the LCD panel and press VOLUME +. (p. 23)
AUDIO MIX is set to ST2 side in the menu system.
■> Adjust AUDIO MIX in the menu system (p. 69).
The new sound added to tlie recorded
tape is not heard. • AUDIO MIX is set to STl side in the menu system.
■> Adjust AUDIO MIX in the menu system (p. 69).
The SteadyShot function does not activate. • STEADYSHOT is set to OFF in the menu system.
-> Sot it to ON. (p. 29)
Recording stops at once. • The POWER switch is set to PHOTO.
Set it to CAMERA, (p. 16)
Recording stops in a few seconds. • The START/STOP MODE switch is set to
5SEC or i.
ANTI GROUND SHOOTING.
-> Set it to Ü. (p. 16)
The autofocus function does not activate. •
•
Focus is set to the manual mode.
^ Set it to autofocus, (p. 44)
Shooting conditions are not suitable for autofocus.
Set focus to manual mode to focus manually, (p. 44)
The fader function does not work. • The START/STOP MODE switch is set to 5SEC or A
ANTI GROUND SHOOTING.
■» Set it to Ü. (p. 16)
The title is not displayed. • TITLE DSPL is set to OFF in the menu system.
Set it to ON in the menu system, (p. 29)
The title is not recorded. •
•
•
•
•
The tape has no cassette memory.
Use a tape with cassette memory, (p. 70)
The cassette memory is full.
Erase another title, (p. 73)
The tape is set to prevent accidental erasure.
Slide the protect tab so that red portion is not visible,
(p. 72)
The fader function is working.
Wait until the fader function is finished, (p. 35)
Nothing is recorded in that position on the tape.
Superimpose the title to the recorded position, (p. 72)
The cassette label is not recorded. • The tape has no cassette memory.
4 Use a tape with cassette memory, (p. 76)
•
•
The cassette memory is full.
Erase some titles, (p. 76)
The tape is set to prevent accidental erasure.
^ Slide the protect tab so that red portion is not visible,
(p. 76)
Displaying the recorded date, date search
function does not work. •
•
The tape has no cassette memory.
-> Use a tape with cassette memory, (p. 52)
CM SEARCH is set to OFF in the menu system.
Set it to ON. (p. 52)
96