Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 158)

-158-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
4.2.65.116 spanning-tree link-type
Command:
spanning-tree link-type auto | point-to-point | shared
spanning-tree
Spanning Tree protocol
link-type
Port link-type
auto
Auto detect
point-to-point
Forced to point-to-point
shared
F orced to Shared
Default:
Auto
Usage Guide:
To configure point to point mode of CIST Normal Port Configuration for specific interface
Example:
To enable point to point mode (shared) of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
4.2.65.117 spanning-tree mst <Instance : 0-7> cost
Command:
spanning-tree mst <Instance : 0-7> cost <Cost : 1-200000000> | auto
spanning-tree
Spanning Tree protocol
mst
ST P bridge instance
<Instance : 0-7>
instance 0-7 (CIST=0, MST2=1...)
cost
STP Cost of this port
<Cost : 1-200000000>
Cost range
auto
Use auto cost