Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 82)

-82-
Default:
V2
Usage Guide:
To configure ERPS VLANs for the specific profile.
Example:
To configure ERPS VLANs(VLAN5 - VLAN8) for the specific profile 1.
Switch# configure terminal
Switch (config)# erps 1 vlan add 5-8
4.2.51 evc
Command:
evc <EvcId : 1-4096> vid <evc_vid> ivid <ivid> interface ( * | 10GigabitEthernet |
GigabitEthernet [ <port_list> ] ) learning [ disable ] policer { <PolicerId : 1-2048> |
none | discard }
<EvcId : 1-4096>
EVC identifier
vid
Setup EVC VLAN ID
<EvcVid : 1-4095>
EVC VLAN ID
ivid
Setup internal EVC VLAN ID
<Ivid : vlan_id>
Internal VLAN ID
interface
Setup NNI
learning
Setup learning
policer
Policer (ingress bandwidth profile)
<PolicerId : 1-2048>
Policer ID
<vlan_list>
List of VLANs
discard
Map to policer discarding all frames
none
Map to policer allowing all frames
Default:
0
Usage Guide:
To configure Ethernet Virtual Circuits (EVC).
Example:
To configure Ethernet Virtual Circuits (EVC identifier: 1, EVC VLAN ID: 2, GigabitEthernet Port: 1/1, 1/2, Internal
VLAN ID: 3, Disable learning, Policer ID: 4)
.
Switch# configure terminal