Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 188)

-188-
Usage Guide:
To default the function for specific interface
Example:
To disable the function (ip address dhcp) for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# no ip address dhcp
4.2.67 ip arp inspection
Command:
ip arp inspection
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
Default:
N/A
Usage Guide:
To enable ARP inspection
Example:
To enable ARP inspection
Switch# configure terminal
Switch (config)# ip arp inspection
4.2.68 ip arp inspection entry interface
Command:
ip arp inspection entry interface [10GigabitEthernet | GigabitEthernet] <vlan_id>
<mac_ucast> <ipv4_ucast>
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
entry
arp inspection entry
interface
arp inspection entry interface config
GigabitEthernet 1 Gigabit Ethernet Port