Interlogix NS4702-24P-4S-4X Command Line Guide - Manual (Page 316)

-316-
Usage Guide:
To configure the VLAN Translation
Example:
To enable the VLAN Translation (below table)
Switch# configure terminal
Switch (config)# switchport vlan mapping 1 3 5
4.2.215 tacacs-server deadtime
Command:
tacacs-server deadtime <minutes>
tacacs-server
Configure TACACS+
deadtime
Time to stop using a TACACS+ server that doesn't respond
<Minutes : 1-1440>
Time in minutes
Default:
0
Usage Guide:
To configure the Deadtime of TACACS+ Server
Example:
To enable the Deadtime (6) of TACACS+ Server
Switch# configure terminal
Switch (config)# tacacs-server deadtime 6
4.2.216 tacacs-server host
Command:
tacacs-server host <host_name> [ port <port> ] [ timeout <seconds> ] [ key <key> ]
tacacs-server
Configure TACACS+
host
Specify a TACACS+ server
<HostName : word1-255>
Hostname or IP address
key
Server specific key (overrides default)