Interlogix Concord 4 REV J Installation Manual - Manual (Page 40)

Chapter 3: Programming
34 Concord 4 Installation Manual
Overview
For onsite system programming, you must have an alphanumeric touchpad.
You must use an installer/dealer code (default = 4321) to enter program mode.
You must disarm all partitions before you can place the system into program
mode.
Note: If the system is powered up after the programming touchpad is connected
or if a bus command scan is executed, the programming touchpad will be
“learned” into the system and must later be manually deleted.
To enter program mode:
1. Make sure you disarm the system in all partitions.
2. Press 8, 4321, 0, 0. The display shows SYSTEM PROGRAMMING.
To enter program mode using a programming touchpad:
1. Connect the red, black, green, and white wires from the programming
touchpad cable (60-791) to the power and bus wires/terminals on an
alphanumeric touchpad, matching the +12V (red), Bus A (green), Bus B
(white), and GND (black) on each.
2. Make sure the system is powered up and disarmed.
3. Connect the plug on the cable onto the panel programming touchpad header
(see Figure 27 on page 35).
4. Press 8, 4321, 0, 2. The touchpad sounds one short beep. Press * and verify
that the display shows SERVICE TOUCHPAD ACTIVE.
5. Press 8, 4321, 0, 0 and the display shows SYSTEM PROGRAMMING.
6. After programming is complete, disconnect the touchpad from the panel
header.