Interlogix Concord 4 REV J Installation Manual User Manual
Page 91
Chapter 3: Programming
Concord 4 Installation Manual
85
Direct bypassing
Shortcut: 030nnn1,
where nnn is user
number 00 to 229
Default: Off
This setting determines whether a specific user code provides access to
the bypass sensors feature. Set this feature to on for all users who need
to be able to bypass sensors.
To turn the direct bypassing setting off or on:
1. With the display showing
USER CODES
, press #
and the display
shows
REGULAR USER CODES
.
2. Press #
and the display shows
USER nnn
(first available user
number).
3. Press A
or B
to select the desired user number, then press #. The
display shows
USER nnn - nnnn
.
4. Press A
or B
until the display shows
DIRECT BYPASSING
OFF/ON
(current setting).
5. Press 1
(off) or 2
(on). The display flashes the entered setting. Press
#
and the display shows the new setting.
Remote access
Shortcut: 030nnn2,
where nnn is user
number 000 to 229
Default: Off
This setting determines whether the user can access the panel from a
remote phone (a phone located off the premises).
To turn the remote access setting off or on:
1. With the display showing
USER CODES
, press #
and the display
shows
REGULAR USER CODES
.
2. Press #
and the display shows
USER nn
(first available user
number).
3. Press A
or B
to select the user number, then press #. The display
shows
USER nnn - nnnn
.
4. Press B
until the display shows
REMOTE ACCESS ON/OFF
(current setting).
5. Press 1
(off) or 2
(on). The display flashes the entered setting. Press
#
and the display shows the new setting.
System tests
Shortcut: 030nnn3,
where nnn is user
number 000 to 229
Default: Off
This setting determines whether a specific user code provides access to
the phone and sensor tests. Set this feature to on for all users who need
to be able to conduct phone and sensor tests.
To turn the system tests setting off or on:
1. With the display showing
USER CODES
, press #
and the display
shows
REGULAR USER CODES
.
2. Press #
and the display shows
USER nn
(first available user
number).
3. Press A
or B
to select the user number, then press #. The display
shows
USER nnn - nnnn
.
4. Press A
or B
until the display shows
SYSTEM TESTS OFF/ON
(current setting).
5. Press 1
(off) or 2
(on). The display flashes the entered setting. Press
#
and the display shows the new setting.