SINGER 8019 - Manual (Page 14)

Inserting a bobbin
To insert a bobbin, follow the instructions
below:
• Raise presser foot.
• Turn hand wheel toward you until needle
is in its highest position.
• Open slide plate and remove empty bobbin.
1. Pull 4" (10cm) of thread from replacement
bobbin and insert bobbin into case, as
shown.
2. Holding bobbin in place, guide thread into
notch (1) and then down the slot to the
left and guide around into notch (2).
• Draw several inches of thread diagonally
across the bobbin toward the back of the
machine.
• While holding thread on outside, close the
slide plate, allowing thread to extend
through the slot between the slide plate
and needle plate.
• Follow directions for “Raising Bobbin Thread”
below.
Raising the Bobbin Thread
1. Hold needle thread lightly with left hand
and turn hand wheel slowly toward you
so that needle enters needle plate.
2. Continue turning hand wheel until needle
rises and brings up bobbin thread in a loop.
3. Undo the loop and place both threads
under the presser foot, drawing them to
the back of the machine. Position needle
In fabric where desired, lower the presser
foot and stitch.
12