Setting selectors, Optional), Sewing a seam pin basting – SINGER 8019 User Manual
Page 20: Sewing a seam, Straight stitching, L x 1
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3
straight Stitching
setting selectors
Before m aking any setting adjustm ents, raise
the needle out of the fabric.
• Pattern Group; Any Yellow Pattern
• stitch Width: 0] I fit
• Needle Position: L «L
• Stitch Length: To suit fabric
• Zig-Zag or Straight Stitch Foot
When your fabric or sewing procedure re
quires close control, you may wish to use the
straight stitch presser foot and the straight
stitch needle plate that come with your ac
cessories.
L X 1
(optional)
sewing a seam
Pin Basting
Pin basting is a time saver and can be used in
place of hand basting when you are sewing
seams in easy-to-handle fabrics. When sew
ing with pins it is important to use fine pins
and to place them correctly in relation to the
stitching line.
Place pins so that:
• They are at right angles to the stitching line.
• They just nip Into the fabric at the stitching
line.
• They do not extend under both sides of the
presser foot.
Never
place
pins
on
the
underside
of
the
fabric
in
contact
with
the feed.
•
• Sew, pulling pins out of fabric as you stitch.
W e do not recom m end sewing over pins.
18