To remove bobbin case, To replace bobbin case, Removing and replacing bobbin case – SINGER 8019 User Manual
Page 52
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing and replacing
bobbin case
Caution:
Before cleaning or adjusting the
machine, remove plug from the socket outlet.
• Raise presser foot and needle.
•
Open slide plate, remove bobbin and
remove needle plate (see instruction on
page 7).
To remove bobbin case
e
With a small screwdriver, turn bobbin case
holder (1) to the rear as far as it will go.
e Lifting the left side of the bobbin case, slide
it out from machine.
To replace bobbin case
• Guide forked end (2) of bobbin case under
feed (3).
• Draw rim of bobbin case under position
plate (4). Be sure bobbin case is freely
seated on hook race.
e
Turn bobbin case holder (1) forward as far
as it will go, locking bobbin case in place.
Note:
Turn handwheel towards you to check
to make sure it is properly replaced.
• Replace needle plate (see Instruction on
page 7).
• Insert bobbin and close slide plate.
50