If machine is to be stored, Changing the light buib, Repiacing the siide piate – SINGER 8019 User Manual
Page 54: Changing the light bulb, Replacing the slide plate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Apply one drop of oil all to places indi
cated.
• Occasionally apply one drop of oil to all
other rotating or moving machine connec
tions to ensure freedom of movement.
After oiling, replace face plate and arm top
cover. Sew a few lines of stitching on a scrap
of material to remove excess oil.
CAUTION:
Do not attempt to adjust the motor
belt.
Contact
your
nearest
Service
Centre
should any adjustment be required.
If Machine Is To Be Stored
Disconnect power-line plug from electric
outlet.
Clean all exposed parts and area behind
face plate.
Swab all exposed metal parts and parts
behind face plate with oil to protect
against rust.
Changing The Light Buib
CAUTION:
Disconnect
the
power-line
plug
from the socket outlet before changing light
bulb.
This machine is designed to use a 15 watt
maximum bayonet base bulb
only.
Remove face plate, as instructed on page 51.
1
. Removing Bulb:
Press bulb into socket and
at the same time turn bulb in direction
shown to unlock bulb pin
(do not attempt
to unscrew the light bulb).
2.
Replacing Bulb:
Press new bulb into soc
ket, with bulb pin entering slot of socket,
and turn it in direction shown to lock bulb
in position. Replace face plate.
Repiacing The Siide Piate
You will not have any occasion to remove the
slide plate. However, if it should accidentally
become disengaged from the machine, it is
easily replaced.
• Raise the presser foot and make sure needle
is in Its highest position.
• Place slide plate in slide way with the front
edge close to, but not covering, the retain
ing spring (as shown).
• With a small screwdriver, lift each end of the
spring
A
into each of the side grooves on the
underside of the plate.
• Draw the plate gently toward you and fully
engage the spring.
• Close slide plate.
52