Labconco Protector ClassMate Laboratory Hoods 69716 - Manual (Page 17)

13
Product Service 1-800-522-7658
Chapter 3: Getting Started
Protector ClassMate
Components
Labconco manufactures Protector ClassMate Fume
Hoods for operation with vertical rising sashes or
combination A-Style sashes. Each of the hoods is
available in 4-foot, 5-foot and 6-foot models. Models
are all 115V.
Locate the hood model you received in the following
group of tables. Verify that the components listed are
present and undamaged.
Protector ClassMate
Laboratory Hoods
General Specifications for All Models
By-pass airflow design. Frame, airfoil and trough
constructed of epoxy-coated steel and aluminum.
Trough extends 1.25" below hood. Tempered safety
glass sash, sides, back and baffle. Factory wired
fluorescent light, blower and light switches. Interior
depth of 25.5" and height of 48". Interior cover plates
for access to plumbing. Factory prepared for up to 4
service fixtures with an additional 4 in the base cabinet,
two duplex electrical receptacles and airflow monitor,
8" diameter exhaust collar. Blower, work surface and
base cabinets are required (not included). For
operation on 115 volts, 60 Hz, 15 amps. Exterior depth
is 32". Exterior height is 59" (overall height including
trough is 60.25").
Additional specifications for Standard Models
Sash provides maximum visibility of 39" high. Vertical
rising sash with anti-racking shaft moves from closed to
18" operating height. Sash moves up past the sash stop
for loading. Fixtured models include two electrical
duplex receptacles and four service fixtures pre-
plumbed with copper tubing. Upper right fixture is
plumbed with brass for gas connection.