Labconco Protector ClassMate Laboratory Hoods 69716 User Manual
Page 21
17
Product Service 1-800-522-7658
Chapter 3: Getting Started
Install the Protector
ClassMate Hood on A
Supporting Structure and
Work Surface
The Protector ClassMate is heavy!
Use caution when lifting or moving the
unit.
When installing the Protector ClassMate Fume Hood
onto a chemically resistant work surface or benchtop,
ensure that the structure can safely support the
combined weight of the fume hood and any related
equipment. The work surface should be at least as wide
as the unit and 25-7/8 inches deep to properly support
the unit.
!
!
WARNING: It is important to support the rear of
the hood. Prior to setting the hood, install the cross
supports after the base cabinets and work surface
are leveled. The wood cross support provides
support for the bottom of the work surface.
Figure 3-4
Cross
Supports