Labconco Protector ClassMate Laboratory Hoods 69716 - Manual (Page 54)

50
Product Service 1-800-522-7658
Chapter 7: Modifying Your Protector ClassMate Fume Hood
Labconco Service Fixture
with Gooseneck
Use the instructions above for the Labconco Service
Fixture except Steps 3 and 4 use the following:
3a. (Gooseneck only) Mount the gooseneck
outlet fitting P/N 6983705 on the sidewall
through the 3/4" diameter hole and tighten the
supplied nut and washer.
3b. (Gooseneck only) Mount the 3/8" female
and 3/8" male street elbow P/N 1402400 to the
gooseneck outlet fitting. Apply pipe sealant P/N
1577900 to the threads. Tighten the fitting with
a wrench or pliers.
3c. (Gooseneck only) Mount the 3/8" pipe x
1/4" tube female connector P/N 4890300 to the
street elbow. Apply pipe sealant P/N 1577900
to the threads. Tighten the fitting with a wrench
or pliers.
4. (Gooseneck only) Connect one end of the outlet
service tube P/N 6984600 to the gooseneck female
connector fitting (from Step 4c) by pressing the tube
all the way into the fitting and through the two
ferrules, turning the tubing nut hand tight, and then
approximately one more turn using pliers or a 9/16"
wrench.
WaterSaver Service Fixture
and/or Gooseneck
1. Decide into which of the available locations
(positions either 1 or 3) you want to install the
service fixture and outlet fitting and then remove
the hole plugs, valve cover, plates, and access
panels. (See Figure 7-2)