Labconco Protector ClassMate Laboratory Hoods 69716 User Manual
Page 58
54
Product Service 1-800-522-7658
Chapter 7: Modifying Your Protector ClassMate Fume Hood
Tools Required:
1. Power Drill
2. Drill bit size #37 (0.104")
3. 33/64" diameter hole saw
4. Reciprocating saw with saw blades for
cutting sheet metal
5. Pilot drill sized to fit the saw blade
6. Phillips head screwdriver with #1 point
7. Slotted screwdriver with 3/32 blade width
Procedure:
Step 1: The mounting location of the monitor shall be
3" down from the top and 7" from the right side
to the centerline located on the front panel. Use
the cardboard template supplied as a guide for
the size of the installed product and the hole
needed to be cut out of the hood. The cutout
required is 3" high by 2" wide, which is the
!
DANGER: Always wear eye protection when using power tools.
Observe all necessary precautions when installing or repairing
monitors near electrical equipment.
Figure 7-4