Labconco Protector ClassMate Laboratory Hoods 69716 - Manual (Page 50)

46
Product Service 1-800-522-7658
Chapter 6: Maintaining Your Protector ClassMate Fume Hood
Changing the Fluorescent Lamp:
1. Turn light switch to “OFF”.
2. Remove the front panel as noted earlier.
3. Reach over the front header of the hood and loosen
screws to the light reflector and remove light
reflector.
4. Remove the fluorescent lamp by pushing it out of
the spring-loaded lamp socket and swinging it out
of the other lamp socket.
5. Install the new lamp by reversing the removal
procedure.
Your Next Step
After you understand the maintenance procedures, you
are ready to proceed to Chapter 7: Modifying Your
Protector ClassMate Fume Hood.
4' 5'
6'
Figure 6-2
Light Reflector