Labconco Protector ClassMate Laboratory Hoods 69716 User Manual
Page 63
59
Product Service 1-800-522-7658
Chapter 7: Modifying Your Protector ClassMate Fume Hood
1. Remove the hole plugs and install the grommets
into the upper baffle.
2. The vertical rods can now be systematically
installed in front of the horizontal rods. The bottom
of the rods slip into the footplates which rest on the
work surface. Tighten the clamping screws on the
footplates. For support you need to drill .147
diameter pilot holes and mount the footplates that
rest on the work surface. Use the additional #8
thread forming screws in the kit to mount the
footplates to the work surface. Another alternative
is to secure the footplates to the work surface with
clear RTV sealant.
3. Install all the hook connectors, which connect all
the vertical rods to the horizontal rods, then install
the horizontal rods. Please note that all the vertical
rods are in front of the horizontal rods. Simply
tighten all the thumbscrews on the hook connectors.
4. The installation is now complete and is ready to
mount your apparatus.