Labconco Protector ClassMate Laboratory Hoods 69716 - Manual (Page 19)

15
Product Service 1-800-522-7658
Chapter 3: Getting Started
Removing the Shipping
Skid
LEAVE THE FUME HOOD
ATTACHED TO ITS SHIPPING SKID
UNTIL IT IS AS CLOSE TO ITS
FINAL LOCATION AS POSSIBLE.
MOVE THE UNIT BY USING A
SUITABLE FLOOR JACK, OR BY
PLACING A FURNITURE DOLLY
UNDERDNEATH THE SKID. DO
NOT MOVE THE HOOD BY TILTING
IT ONTO A HAND TRUCK.
After you verify the fume hood components, move your
hood to the location where you want to install it. Then,
follow the steps listed next to remove the shipping skid
from your unit.
)