D3_delay – Altera Quartus II Settings File User Manual
Page 477
D3_DELAY
Specifies the propagation delay for D3 Delay Cell. This is an advanced option that should be used only
after you have compiled a project, checked the I/O timing, and determined that the timing is
unsatisfactory. For detailed information on how to use this option, refer to the data sheet for the device
family. This option is ignored if it is applied to anything other than an input or bidirectional pin.
Old Name
T3_DELAY
Type
Integer
Device Support
This setting can be used in projects targeting any Altera device family.
Notes
This assignment supports Fitter wildcards.
Syntax
set_instance_assignment -name D3_DELAY -to <to> -entity <entity name>
<value>
set_instance_assignment -name D3_DELAY -from <from> -to <to> -entity
<entity name> <value>
MNL-Q21005
2015.05.04
D3_DELAY
477
Quartus Settings File Reference Manual
Altera Corporation