Altera Quartus II Settings File - Manual (Page 487)

D6_OE_DELAY
Specifies the propagation delay for D6 Output-Enable Delay Cell. This is an advanced option that should
be used only after you have compiled a project, checked the I/O timing, and determined that the timing is
unsatisfactory. For detailed information on how to use this option, refer to the data sheet for the device
family. This option is ignored if it is applied to anything other than an output or bidirectional pin.
Old Name
T10_OE_DELAY
Type
Integer
Device Support
This setting can be used in projects targeting any Altera device family.
Notes
This assignment supports Fitter wildcards.
Syntax
set_instance_assignment -name D6_OE_DELAY -to <to> -entity <entity name>
<value>
MNL-Q21005
2015.05.04
D6_OE_DELAY 487
Quartus Settings File Reference Manual Altera Corporation
Send Feedback