KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 20)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 20 of 88
6. Opening the Transport Case
In the SEQUENZA 5 transport case three SEQUENZA 5 W speakers are safely packed. When
dismantling the speakers, you can leave them connected in any given tilt angle. You need
not remove or loosen the rear connectors. This makes them easier to dismount and faster to
disassemble.
To remove the transport lid, turn the
appropriate catches 180° to completely
release the latch.
Once you have released catches, you can
lift off the lid.
To remove the front lid, you must open
two catches.
To remove the main lid, you must also
open the four bottom catches.
You close the case by following these steps in reverse order.
7. Using the Spring Bolt
The spring bolt is the central bolt of the 'Snap&Fly+' rigging system.
It can be set to four positions that you have either set manually or that have come about
because of the handling of the speakers.
Initial position:
The spring bolt is under tension. You can
mount a standard connector.