KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 21)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 21 of 88
Waiting position:
In this position, the spring bolt is
connected to a standard connector (not
shown) and is 'waiting' for the speaker to
move, snapping into its locking position.
Locking position:
In this safe position, the spring bolt is
holding a connector.
On the opposite side, the spring bolt
protrudes.
Release position:
The spring bolt can only be manually
moved to this position.
To release a connector from the spring
bolt, the user must pull the spring bolt as
far as it will go and hold onto it.
8. Safe Connecting and Disconnecting of the Products
To safely connect or disconnect the products, you always need the same hand grips. In
general, the joints must always be connected and the appropriate speaker connector must
be used and attached to the other speaker, flying frame, or adapter. To prevent inadvertent
loosening, you must always ensure that the safety latch snaps over each joint. When you have
mounted everything correctly, a red dot is visible on the safety latch.
For disassembly, release the connector first and then fasten it in its parking position. After
doing so, you must then push the safety latch into the enclosure using one hand, then release
the product to be dismantled to the side and then completely release it.
Tip
The safety latch is always on the speaker.
In general, all SEQUENZA 5 speakers can be safely connected to one another and with the
SEQUENZA 5 adapters this way.