KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 45)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 45 of 88
4. Adjust every speaker to the
tilt angle calculated by the
simulation software:
Align the drill hole of the
connector with the drill
hole that is marked with the
desired angular degree.
Fasten the connector with
the ball lock pin.
Make sure the ball lock pin
is secured and clicked into
place.
5. Fold out the connector
and push it between the
connecting plates and into
the drawn back spring bolts
of the next speaker.
In doing so, the spring bolt
clicks into the track of the
standard connector into its
locking position.
6.
Caution
It is absolutely necessary
that you lock the rear
bolts into place.
When lifting the array, the
connector is secured by the
spring bolt, indicated by a
loud clicking noise.