KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 35)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 35 of 88
9.3.3 Mounting SEQUENZA 5 B to SEQUENZA 5 Flying Frame,
Flown
1. Prepare the flying frame for flying mode. (see chap. 'Preparing the Sequenza 5
Flying Frame' on page 30)
2. Connect the SEQUENZA 5
flying frame with the
SEQUENZA 5 B speaker
as explained in chapter
'Safe Connecting and
Disconnecting of the
Products' on page 21.
Make sure you can see the
red dot on the safety latch.
3. To connect a SEQUENZA 5 B
speaker with a SEQUENZA 5
flying frame, you must use
the provided L-bracket of
the speaker.
To connect the L-bracket
to the rigging frame, reach
into the side opening of the
speaker and swivel the L-
bracket down by nearly 180
degrees.
Align the drill holes of
the L-bracket with the
corresponding drill holes of
the flying frame.
Secure the connection with
the removed ball lock pins.
Tip
Make sure that the L-
bracket is in a sloped
position after you have
completed the setup.
Make sure the ball lock pin is
secured in place.
The speaker is now completely assembled and secured.
If you don't want to mount any more speakers, then you can now wire the speakers.
Further information in chapter 'Wiring' on page 65.
Detailed information for connecting the speakers and configuring the K&F system amplifier
TOPAS or the K&F SystemRack is in the hardware manuals.