KLING & FREITAG K&F SEQUENZA 5 W User Manual
Page 23
User's manual
K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015
Version 4.1
Page 23 of 88
In general, all SEQUENZA 5 speakers and SEQUENZA 5 adapters can be safely disconnected
this way.
Warning
To avoid injury, it is forbidden to separate speakers from one another while they are still
suspended or strapped.
Take the load off the speakers' connecting points by laying the array onto the castor base of
the transport case or by vertically lowering three speakers at a time into transport cases, thus
lessening the load.
1.
Loosen the connector on the
spring bolt.
Do this by pulling the spring
bolt out and holding it
in this retracted position
(release position, compare
to 'Handling the spring bolt',
page 20).
Pull the connector out
and fold it between the
connecting plates.
When all connections have
been released, fasten the
connecter with the speaker's
own spring bolt.
Tip
You should completely
disassemble the flying
frame connector and
fasten it in its parking
position on the rigging
frame.
You should now mount
the SEQUENZA 5 W
connectors that you
parked on the rigging
frame during setup back
onto the speaker.
2.
Using both hands, grasp
to the right and left of the
connecting joints and push
the safety latch into the
speaker using one finger.