KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 63)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 63 of 88
2. Completely remove the
SEQUENZA 5 speaker cable
split adapter out of the
wiring.
When the connection is
relieved, loosen the spring
bolt on the fourth speaker.
3. Grasp to the right and left
on the speaker's connecting
joints and push the safety
catch into the enclosure.
While doing so, push the
top speaker to the side so
that the speakers disconnect
from one another.
4. Slightly lift the still flown
speakers.
Close the transport case, tip
it onto the castors and slide
it to the side.
The triple is now completely
disassembled and packed
into the transport cases.
Proceed in the same manner
with the remaining speakers.
5. Loosen the flying frame
from the topmost
SEQUENZA 5 W speaker
as described in chapter
'Safe Connecting and
Disconnecting of the
Products' on page 21.
Fold the flying frame
connector against the built-
in magnet.
Lower the flying frame to
the ground and separate it
from the hoist.
10.1 Flown Disassembly