KLING & FREITAG K&F SEQUENZA 5 W - Manual (Page 25)

User's manual K&F SEQUENZA 5 incl. accessories
KLING & FREITAG GMBH © 2015 Version 4.1 Page 25 of 88
Caution
The simulation software CON:SEQUENZA+ must always verify the number of speakers.
It is generally prohibited to exceed the maximum number of 15 speakers.
To prevent damage to persons and property, you must set up or suspend the array in
compliance with the specifications of the German safety regulation BGV C1 or comparable
applicable national standards.
Always assemble the complete rigging frame first before connecting the rigging frame to the
speakers.
During setup, always make sure to use the correct connectors. When connecting the
SEQUENZA 5 flying frame with a SEQUENZA 5 W speaker, you must always use the flying
frame connector.
Using a wrong connector or incorrectly installing a connector can result in certain tilt angles
being impossible or the array tipping because of a shifted centre of gravity. This would
lead to unfavourable acoustic results. For this reason, always follow the depictions and
descriptions mentioned in this manual.
The following illustrations show you the possible setup variations with the corresponding
chapters in which the working steps for the setup are explained.
see following chapter:
•
General Preparation
• SEQUENZA 5 Flying Frame
Preparation, Flown Setup
• Mounting SEQUENZA 5 W to
SEQUENZA 5 Flying Frame, page
36
• Mounting SEQUENZA 5 W to
SEQUENZA 5 W, Flown, page 40